confreecut zinczero: The solution for zinc-free wire EDM
Medical technology and the semiconductor industry place particularly high demands on component surface cleanliness. With confreecut zinczero, bedra expands its portfolio with three completely zinc-free EDM wires for applications where zinc contamination must be avoided.
In conventional wire EDM, constituents of the wire can be transferred to the machined component surface. Choosing the right EDM wire is therefore essential for sensitive applications.
The new confreecut zinczero product family addresses this challenge: All three variants are uncoated and completely zinc-free. In tests, no zinc residues were detected on the machined surface after the first cut.
Three variants for different requirements
- confreecut zinczero.9 offers a tensile strength of 900 MPa and is suitable for threading systems designed for hard, straightened brass wires.
- confreecut zinczero.5 offers a tensile strength of 500 MPa and is the preferred variant for other threading systems.
- confreecut zinczero.4 is made from oxygen-free copper and is intended for applications where oxygen contamination must also be avoided in addition to zinc contamination. Its tensile strength is 500 MPa.
Zinc-free machining – cost-effective production
Compared with molybdenum and tungsten wires, confreecut zinczero EDM wires offer lower wire costs and very low wire guide wear.
All three variants are available in diameters of 0.20, 0.25 and 0.30 mm on the 8 kg bedra8 spool. Further information and the new brochure are available on our product pages.
Discover confreecut zinczero and find the right variant for your application


